Page d'accueil de Aeropassion
Partenaires du site :
Envoyé par rui 
carte contrôleur commune
jeudi 29 septembre 2011 01:34
I made this control board,,
but does not work with Jedicut,
how do i connect it?
Re: carte contrôleur commune
jeudi 29 septembre 2011 12:24
Hello Rui,
You must connect the "step" and "dir" pins of your interface with a parallel port, and configure Jedicut to obtain the correct assignation of the pins "step" and "dir".

For example, connect the "step" on the pin 2 of the parallel port, and "dir" on the 3rd pin.

Launch Jedicut, go to "tools", "options", "communication", and select correct pins assignment : 2 for the step, and 3 for the direction.
Your motor should turn if you send an order in manual control.
Re: carte contrôleur commune
jeudi 29 septembre 2011 23:50
Thanks for your help.
I've done all this but the engine just tremble, do not rotate.
With the software CENECE the engines spin well,
I have tried all settings available in the JEDICUT, dll's, and nothing works.
Can you help more?
Re: carte contrôleur commune
vendredi 30 septembre 2011 20:22
ok, so you may try to increase the cut speed and fast speed values in "options", tools", CNC controller.

for example, try this :

nb mm.pas : 0,020780
cut speed : 30000000
fast speed : 15000000

(modify for all axis of course)
Désolé, seuls les utilisateurs connectés peuvent envoyer des messages dans ce forum.

Cliquer ici pour se connecter

Et vous, vous venez d'où ?


Paris en photo | Design by Le Flaketou, création de site internet