Aeropassion's homepage
Aeropassion's parteners :
Posted by Jerome 
Parallel Port Function
May 28, 2007 11:26AM
we would use jedicut with Hobbycnc.
After Install the jedicut software we would test the II Port.
Can we use parmon.exe to test II port.

Can we use a standard II Port cable.

Witch BIOS II option is used for jedicut.

PC with Win 98.

Gruß Sucramsni
Re: Parallel Port Function
May 29, 2007 11:05AM
Hello,

You can test parallel port with parmon but only in order to test a signal like "Engine On/Off". Configure Jedicut like I do for MM2001 board.

I'm sorry but I don't know what kind of cable you have tu use. Contact HobbyCNC winking smiley

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum