Aeropassion's homepage
Aeropassion's parteners :
Posted by Jens 
CNC Step + own Timer
April 17, 2008 08:52PM

I have a 3D Step controller, a friend got a GWR Controller.
Both dont got a timer on board and offer the timer signal on pin 10.

At I found a small circuit, to build a small timer.

Question: if I built this timer and attach the signal on PIN 10, would this work with Jedicut?

Right now we got with the GWR device major problems. Jedicut is more or less not useable.

An thoughts, comments, ideas?

Jens ( )
Re: CNC Step + own Timer
April 17, 2008 10:55PM

Jedicut works with or without external timer. But your cnc board need to be compatible with the kind of signals Jedicut send.

Sorry, only registered users may post in this forum.

Click here to login


Paris en photo | Design by Le Flaketou, création de site internet