Hi,
does Jedicut works with the interface from pro-tos (Langenfeld)?
http://www.pro-tos.de/
Michael
Re: Jedicut + interface from pro-tos
2Hi,
Do you have documentation to know what signals the software have to send ? Do you try existing dll of Jedicut ?
Do you have documentation to know what signals the software have to send ? Do you try existing dll of Jedicut ?
Jerome
Re: Jedicut + interface from pro-tos
3Hi Jerome,
there is an english documentation: http://www.pro-tos.de/ ( -> Download -> Parallel Interface)
I'm planning to build the foam cutter from 'Ticmic' http://www.rc-network.de/forum/showthre ... t=styro%2A
and for that I want to buy 4 motor drivers HP5056 and the Parallel Interface from pro-tos.
Michael
there is an english documentation: http://www.pro-tos.de/ ( -> Download -> Parallel Interface)
I'm planning to build the foam cutter from 'Ticmic' http://www.rc-network.de/forum/showthre ... t=styro%2A
and for that I want to buy 4 motor drivers HP5056 and the Parallel Interface from pro-tos.
Michael
Re: Jedicut + interface from pro-tos
4Hi,
I'll take a look at this doc but now I don't have many times...
I'll take a look at this doc but now I don't have many times...
Jerome