Aeropassion's homepage
Aeropassion's parteners :
Posted by urology 
urology
Heat parallel control
June 15, 2008 11:20AM
Is there a way to set the parallel pin for heat control in CncNet_XP.dll. I use a PCB of HobbyCNC.
http://www.hobbycnc.com/products/auto-heat-and-timer-board-kit/

Thanks
urology
Re: Heat parallel control
June 15, 2008 02:20PM
UP.....
This is a question not a sentence!!!
urology
Re: Heat parallel control
June 15, 2008 02:46PM
OK!
The questin is: on my pcb AHATB of HobbyCNC i have:
pin 10=timer
pin 11=heat feadback
pin 12=auto/manual heat control
pin 16= heat.

How can i set Jedicut for the pin of mY board???
Re: Heat parallel control
June 19, 2008 05:41PM
Hi,

It's the same pin configuration on MM2001 board. Jedicut will control wire heating winking smiley

Jerome
urology
Re: Heat parallel control
June 23, 2008 08:31AM
Thank you!
All OK.

But i have another question.
Is there a way to set wire radiation in Jedicut?
Re: Heat parallel control
June 23, 2008 08:16PM
Hi,

Yes, it's called thickness in Jedicut winking smiley

Jerome
urology
Re: Heat parallel control
June 25, 2008 02:58PM
Yes thank you!
I can performe some test before cuttin.

Another question:
How can i convert .cnc file (GMFC) for use with Jedicut?
Re: Heat parallel control
July 03, 2008 10:48PM
Hi,

I think someone explain this on this board but I don't remember when, and I don't fin the message... I'm searching...

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum