Aeropassion's homepage
Aeropassion's parteners :
Posted by Prboz 
Prboz
Jedicut configuration
September 21, 2008 05:10AM
Hi there,

I am tring to set jedcut up to work with a pminmo breakout board. I need to be able to change the the engine on / off to Pin 14 and not 17. If I try and change this the numbers do not change.

Regads

Prboz
Prboz
Re: Jedicut configuration
September 21, 2008 07:31AM
I am actually using mach3 with with this board.

regards
Re: Jedicut configuration
September 21, 2008 10:29AM
Hi,

This is normal. I block this functionality because if some users set a bad configuration, the parallel port burn... Can you modify your board parallel port pin ?

Jerome
Prboz
Re: Jedicut configuration
September 22, 2008 01:44AM
Hi Jerome,

Not easily, it is set to pin 14 on the pcb so that makes it a little tough. could you modify and send a file to change it to 14?

Thanks

Prboz
Re: Jedicut configuration
October 02, 2008 11:22PM
I can try to send to you a special Jedicut version but you can quickly test it by modifying your parallel port link.

Jerome



Edited 1 time(s). Last edit at 02/13/2009 08:07PM by Jerome.
Re: Jedicut configuration
February 13, 2009 09:34AM
Why not free setting Engine on/off bit and other heating bits (V2.1.9)?

www.hobbycnc.hu
Re: Jedicut configuration
February 13, 2009 08:08PM
Because of bad configuration of Jedicut's users winking smiley A bad configuration can burn parallel port. So I decided to add many control, and I have to test it.

Jerome
Re: Jedicut configuration
February 13, 2009 08:28PM
My Controller fix wirred, therefore need more liberty config in software.eye rolling smiley

www.hobbycnc.hu
Joachim
Re: Jedicut configuration
March 05, 2009 08:27PM
I'm interreset in a more liberty config as well
Jerome maybe you can do a version for people like us ;-)
a pinsetup in the ini file it is fine for me; i do not need a gui


Reg

Joachim
Re: Jedicut configuration
March 09, 2009 08:49PM
Not in the next Jedicut version, but the one after winking smiley

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum