Aeropassion's homepage
Aeropassion's parteners :
Posted by Frank 
Frank
Horizontal movement for wing root and tipp
September 13, 2009 01:40PM
Hello,
I would like to cut a Wing where the length oder the wing root is 300mm an the wing tip only 100mm. My problem is, that after the horizontal movement the heating wire waits at the begining of the wing root till the begining of the wing tip is reached. While this time the heating wire stands at the same position and damage (melt) this position of the wing root. Is there a possibility to change the sequence, that first the movement is done to reach the difference between the wing root an tip an after that the heating wire make the horizontal movement for the wing root and tip?
I hope you can understand my describtion confused smiley
Best regards
Frank
Re: Horizontal movement for wing root and tipp
September 14, 2009 08:36PM
Hello,

I'm working on this problem and a french users are is still testing a new beta Jedicut release winking smiley

Jerome
Frank
Re: Horizontal movement for wing root and tipp
September 18, 2009 05:56PM
Hello Jerome,
thank you for the good news. I will check on the homepage from time to time for a new versionthumbs up.
Frank
Frank
Re: Horizontal movement for wing root and tipp
October 25, 2009 08:08PM
Dear Jerome,
is this function integrated in the new version 2.2.1?
Best regards
Frank
Re: Horizontal movement for wing root and tipp
October 26, 2009 07:38PM
Yes winking smiley

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum