Aeropassion's homepage
Aeropassion's parteners :
Posted by Tomas 
Tomas
Problems with the Wizard
January 13, 2011 09:25PM
Hi!

I've been for the last days trying to figure out what i am doing wrong with the wizard.

If i load the same cut file (.dat) in the two windows with different lenght (chord) i can use the wizard to place my piece of foam in the correct place with the correct sweep it works great.



If i load two different files it goes crazy when i check the Cut wizard box.



I have removed all except the profile in the cut preview. (ie only intrado and extrado left)

If i uncheck the Wizard it works, to fix the sizes of the two profiles is a pain due to the distances between the X1 and X2.

Any ideas how to make this work? Is it even possible?


Regards

Tomas
Sweden
Re: Problems with the Wizard
January 23, 2011 08:21PM
Hello !

I'm sorry, I think you find a case where error occurs. This wizard need a very complex algorithm, and I have to work on it... You can try to move your foam bloc on the table and try new simulation.

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum