Aeropassion's homepage
Aeropassion's parteners :
Posted by Telefisch 
Telefisch
Not sure if Jedicut is right for me
May 05, 2011 08:43PM
Hi guys,
actually I'm working with S4Cut from StepFour.
This is a really nasty DOS-based application and I need to get rid of it.
For this I'm searching for a new Software which should work on WinXP or higher.
My Hardware is this here:

http://shop.strato.de/epages/61125483.sf/de_AT/?ObjectPath=/Shops/61125483/Products/SM44PCV5.2

It's controlled over parallel port.
I'm looking for a software, where I could load dxf files, define cutting-settings and directly cut on my machine.
Could Jedicut do this job ? Or do I need any additional software ?
Perhaps there is a german manual available for jedicut or at least an english?

Many thanks
Tele
Re: Not sure if Jedicut is right for me
May 07, 2011 10:52PM
Jedicut doesn't open dxf files very well but I'm working on it. Jedicut support german language but help file is only available in english and french.

Jerome



Edited 1 time(s). Last edit at 05/08/2011 10:03AM by Jerome.
Telefisch
Re: Not sure if Jedicut is right for me
May 08, 2011 09:42PM
Hi Jerome,
I tried it and, as you said, dxf seems to be a problem.
Is there a better version available soon or is there any workaround how to solve the problems?
Re: Not sure if Jedicut is right for me
May 09, 2011 08:46AM
Hello,

I'm actually working on a new solution.

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum