Aeropassion's homepage
Aeropassion's parteners :
Posted by Sleedo 
Sleedo
Single pass cut?
May 21, 2006 02:02PM
Can you provide some instruction for making single pass wing cuts in the new version please?

Thanks,
EB
Sleedo
Re: Single pass cut?
May 21, 2006 02:04PM
Never mind, just found the "inverse" check box. smiling smiley

Thanks, lovin' the software!
Re: Single pass cut?
May 30, 2006 03:05PM
Hello all

Please tell me, where is these check box?
How could i do a Singel Pass Cut?

In the new Version i get some Problems with Skin Thickness in Inverse Mode. It is not working.

Gruß Ingo
Re: Single pass cut?
May 30, 2006 06:28PM
Hi,

Skin thikness don't work with all profiles. I have to improve it. Since last Jedicut verison I don't change it.

When you open the "Cycle of Cut" window configuration, you can see a checkbox between all others steps options called "inverse". This check box is enabled only when you click on extrado or intrado in the steps list.

Jerome
Re: Single pass cut?
May 31, 2006 10:49AM
Many Thanks,

your Software is great.
Go on with that Projekt.

Bests Regards from Germany

Ingo
steve henne
Re: Single pass cut?
February 27, 2007 12:39AM
I assume a 'single pass cut' is when the hotwire cuts around the profile without having to do the top and bottom in seperate runs.... then how does clicking the 'inverse' box in the wing page change anything? I look at the cycle cut manager , after clicking inverse (as explained above) and their are lines in weird directions, it doesn't make sense. Help! :-)
Re: Single pass cut?
March 01, 2007 08:28PM
Hi,
With the default cycle of cut, is the cur correct ?
Take a look at your profile in order to check if you don't have more null point than needed.

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum