Aeropassion's homepage
Aeropassion's parteners :
Posted by Hondaman 
Hondaman
Jedicut for DIY CNC machine?
April 04, 2012 11:07PM
I see how you use the different plug-in DLL's for the different brands of CNC machine, but what about a homemade CNC machine? Is there a plug-in for a standard enable/direction/step parallel port protocol of how does one configure Jedicut for a CNC machine not in the list?

Thank you in advance for your answer.
Re: Jedicut for DIY CNC machine?
April 05, 2012 01:07PM
Hello,

Plugins are made for all kinds of cnc machine. if you build your own cnc board, you have two possibilities :
- you can create a cnc board compatible with existing plugins
- you can program your own plugins and share your project.

Why do you ask this question ? Do you have a project in mind ?

Jerome
Hondaman
Re: Jedicut for DIY CNC machine?
April 06, 2012 09:44AM
There are several CNC kits that use the parallel port and read step/direction signals to work. I was wondering how I'd go about using this app with one of those.
Re: Jedicut for DIY CNC machine?
April 07, 2012 08:58AM
Many of this cnc board are compatible with Jedicut even if this boards don't have external timer.

Jerome
Mike
Re: Jedicut for DIY CNC machine?
October 21, 2014 05:06AM
Hello.
I have built a cnc hotwire cutter and have downloaded your software. I have been trying to get it to work with my stepper motor drives with no luck. Will your software be compatable with the drives I am using. They are Gecko drives and I am using bipolar motors. I am not sure which communication protocol to use. At times I can get the motors to jump a few degrees but no consistant movement. I do not have any type of timer in the circuits. I appreciate any thoughts you might have. Thank you in advance.
Regards
Mike Paciga
Re: Jedicut for DIY CNC machine?
October 21, 2014 04:23PM
Hello and welcome winking smiley

What kind of signal do your cnc need ? Jedicut use a direction signal and a step signal for each motor.

If your board works like this, you have to control the pin configuration in Jedicut's settings.

If it's ok, control your speed value.What do you set up ?

Before all of this, choose the right communication plugin. What do you use ?

Jerome
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum