Aeropassion's homepage
Aeropassion's parteners :
Posted by foxbox 
MM2001 does not work with Jedicut
October 07, 2012 10:55PM
Hello all. Please help me.

My MM2001 still not to work with Jedicut. With GMFC working properly but does not respond to commands from Jedicut.
Motor LED on MM2001 still not flashing if Jedicut run in cut mode, but but the indicator shows correctly during the cutting process to the end.
I have set CncNet_XP.dll plugin and running on WinXP sp3.


Thank you very much. Peter
Re: MM2001 does not work with Jedicut
October 10, 2012 08:26AM
Hello,

What speed values do you set up ?

If you have problem I think that you should uninstall gmfc parallel port driver.

Jerome
Re: MM2001 does not work with Jedicut
October 14, 2012 09:40PM
Thanks very much Jerome.

My problem was bad values ​​in setting for the motor and CNC controller.
Nb mm / passport I have now 0.005 and everything is perfect.
Motor LED in mm2001 not flashing as when working with GMFC, it confused me too.

I am satisfied with Jedicut.

smileys with beer
Sorry, only registered users may post in this forum.

Click here to login



Aeropassion

Paris en photo | Design by Le Flaketou, création de site internet

Phorum